Fast, Reliable Attic Insulation Across Irving
Attic insulation in Irving typically runs $1.50-$4.00 per square foot installed, depending on whether you’re topping up settled fiberglass or doing a full removal and replacement. Blown-in fiberglass for a standard 1,500-square-foot attic usually lands between $2,200 and $3,800, while spray foam runs higher at $4,500-$8,500 for the same space. Walt’s Insulation gets to Irving homes fast, gives you an exact number before work starts, and answers the phone with a real person whenever you call. Reach us at (866) 751-4428 for a free estimate, no trip charge inside the service county.
Why Walt’s Insulation Is Irving’s Preferred Attic Insulation Company
We’re the one down the road, not a franchise operation working out of a call center three states away. Walt Brenner founded this company in 2000, and we’ve been crawling through North Texas attics ever since. When you call Walt’s Insulation about Attic Insulation, you talk to a live person, 24/7. Not a voicemail. Not an answering service. A person who can actually answer questions about R-values, air sealing, and why your upstairs runs ten degrees hotter than your living room.
Every technician who shows up at an Irving home is background-checked and uniformed, so you know exactly who’s walking through your door. Our work carries the Done Right Promise: if it’s not done right, we make it right. No runaround, no “that’s not covered,” no disappearing after the check clears. That guarantee is lifetime, and it applies to every attic we touch in Irving.
We’ve worked in Valley Ranch, Las Colinas, and the older neighborhoods off Story Road and Belt Line. We know what a 1980s Valley Ranch attic looks like before we even climb the ladder. That local knowledge means faster diagnoses, accurate quotes, and fewer surprises for you.
Our Attic Insulation Services in Irving
Blown-In Attic Insulation
Blown-in fiberglass remains the go-to for most Irving attics. We install Owens Corning AttiCat and GreenFiber cellulose, and we can hit R-38 or R-49 in a single afternoon. For the 1960s-1980s tract homes that dominate Irving’s residential core, blown-in insulation fills the gaps and settles evenly across existing joists, which batt insulation simply cannot do as effectively.
Attic Batt Insulation
Batt insulation works well for Irving homes with open, accessible attic floors and consistent joist spacing, particularly in newer construction where the framing is still uniform. We install CertainTeed and Johns Manville batts, cut precisely to fit around can lights, duct runs, and attic access hatches. In Irving’s summer heat, batts hold their R-value well when air-sealed underneath, but they fail quickly if gaps are left around penetrations.
Attic Insulation Top-Up
This is the service we recommend most often for Valley Ranch and other 1980s-era Irving neighborhoods. Original blown fiberglass has settled to a compressed layer that often measures under R-20, which is nowhere near the R-38 Texas energy code expects. We blow fresh insulation directly over the settled material after air-sealing the attic floor. A top-up in Irving usually runs $1,200-$2,500, less than half the cost of a full removal.
Attic Insulation Replacement
Some Irving attics need everything removed first. We see this most in homes that suffered condensation damage during the February 2021 freeze, where wet insulation has matted down and lost its effectiveness. We also recommend removal and replacement when rodent activity has contaminated the existing material. Full replacement in Irving typically runs $2.50-$4.00 per square foot, with the final number depending on access, attic depth, and whether you’re adding air sealing at the same time.
Attic Baffles & Ventilation Prep
Baffles keep your soffit vents open so air can move through the attic. Without them, even brand-new insulation can trap heat and moisture against the roof deck. We install baffles along the eaves before blowing in new material, which matters in Irving where 100-degree days push attic temperatures above 150°F.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Irving
We’re certified installers for Owens Corning, CertainTeed, Johns Manville, Knauf, Rockwool, Icynene, Demilec, and GreenFiber. For Irving homeowners, that means we stock the materials your attic actually needs, not whatever a distributor had on the truck. We keep Owens Corning AttiCat and GreenFiber cellulose on hand for quick top-ups, and we can order Demilec or Icynene spray foam for full encapsulation jobs without the two-week delay you’ll get from a big-box chain. If you already have a brand preference, we’ll match it and install it properly.
Common Attic Insulation Problems We See in Irving Homes
- Settled Valley Ranch fiberglass: Original 1980s blown-in insulation in Irving master-planned neighborhoods has compressed to under R-20, letting summer attic heat radiate into living spaces. We regularly see upstairs bedrooms running 10-15 degrees warmer than the rest of the house.
- Post-Uri condensation damage: The February 2021 freeze hit Irving’s 1960s-1980s tract homes hard. Near-zero air sealing meant warm, moist indoor air migrated into attics, condensed on the underside of roofs, and soaked insulation. That matted, mold-prone material still sits in thousands of Irving attics today.
- Missing or collapsed baffles: Many Irving homes have soffit vents that were never baffled during original construction. Insulation pushes against the roof deck, blocks airflow, and turns the attic into an oven. We fix this before adding any new material.
- Undersized attic access insulation: The pull-down stair or scuttle hole in your hallway ceiling is often just a thin piece of plywood with zero insulation. In Irving, that single weak point can account for a surprising slice of your cooling bill. We insulate and weatherstrip every access point as part of a proper job.
Pricing for Attic Insulation in Irving, TX
Here are the numbers we quote most often across Irving, based on a typical 1,500-square-foot attic:
- Blown-in top-up: $1,200-$2,500
- Full blown-in replacement: $2,200-$3,800
- Batt insulation (new install): $2,500-$4,200
- Spray foam (open-cell, full attic): $4,500-$8,500
- Air sealing + baffles add-on: $600-$1,500
What moves the needle: attic accessibility, how much old material needs removal, whether you’re adding rodent proofing, and whether you opt for spray foam versus blown fiberglass. We give you a flat quote before we start, and we honor it. Standing offers apply to every Irving job: $40 off any repair over $200, a free second opinion on any written estimate, no trip charge inside the service county, and a permanent 10% discount for seniors and veterans. Call (866) 751-4428 and we’ll walk you through an exact number for your attic.
We Also Serve Cities Near Irving
Walt’s Insulation covers Attic Insulation in Irving and the surrounding metro, including Dallas, Mesquite, Lancaster, and Grand Prairie. Scheduling is coordinated from our Dallas-Fort Worth office, and crews are dispatched locally, so response times stay short whether you’re off MacArthur Boulevard or farther out. If you’re on the edge of the service area, call and we’ll let you know straight away if we can get to you same week.
Serving Irving, TX - Our Local Coverage Area
We’re based in the Irving area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Attic Insulation in Irving
Not usually. Most 1980s Valley Ranch homes just need a top-up over the settled original fiberglass, which costs far less than full replacement. But if the original insulation is water-damaged from Winter Storm Uri, matted with rodent droppings, or compressed to under R-10 in places, replacement is the smarter move. We’ll tell you which one your attic actually needs after a quick inspection, and we’ll show you what we’re seeing before you spend a dollar. Call (866) 751-4428 for an honest assessment.
Uri exposed that thousands of Irving homes built in the 1960s through 1980s had almost no air sealing and under-code attic insulation. Ice dams formed on roofs, pipes froze in attic spaces, and condensation soaked through insulation. The upgrade path now includes air sealing the attic floor before adding insulation, not just blowing more fiberglass on top. That’s the only way to protect against the next freeze event, and it’s now standard on every job we do in Irving.
Las Colinas commercial buildings from the 1980s often use raised-access-floor and plenum-ceiling insulation assemblies that were installed to pre-ASHRAE 90.1 specs, a retrofit niche that essentially only exists in Irving’s office core within the DFW market. These jobs require different certifications, load calculations, and bid structures than residential attic work, and most insulation companies in the area aren’t set up for them. We are. If you manage a Las Colinas property, call (866) 751-4428 and we’ll send someone who knows the difference between a plenum ceiling and a standard attic.
Yes, and in most 1990s Irving homes, baffles make a measurable difference. Soffit vents get blocked when insulation pushes against the roof deck, which traps heat and moisture and drives attic temperatures higher than they need to be. Installing baffles restores airflow, which lowers attic temperatures, extends shingle life, and helps your insulation actually perform at its rated R-value. We install baffles before every blown-in job as standard practice, not as an upsell.
For most Irving homes, blown-in fiberglass is still the best value. It hits R-38 or R-49 at a fraction of spray foam’s cost and performs well in vented attics, which is what most Irving houses have. Spray foam makes sense for unvented attics, homes with ductwork in the attic, or homeowners who want the air-sealing benefits built into the insulation itself. In Irving’s climate, spray foam also reduces the radiant heat load more aggressively during 100-degree weeks, but it’s an investment. We’ll quote both and let you decide with real numbers. Call (866) 751-4428 and we’ll walk you through the math for your specific attic.
Call Walt’s Insulation for Attic Insulation in Irving
Our crew recently topped up attic insulation in a Valley Ranch home where the original 1980s blown fiberglass had settled to under R-20, far below current Texas energy code. After air-sealing the attic floor and installing baffles at the eaves, we blew in Owens Corning AttiCat to R-38, and the homeowner reported the upstairs stayed noticeably cooler during the first 100-degree week. That’s the kind of result we aim for on every Irving job.
Whether you’re off MacArthur Boulevard, in a Las Colinas mid-rise, or in a 1970s ranch near Story Road, we’ll get your attic sorted. Live person on the phone, 24/7. Background-checked technicians. The Done Right Promise on every job. Call (866) 751-4428 for a free estimate, or if you already have a written quote from someone else, bring it to us for a free second opinion. No trip charge in the service county, and 10% off for seniors and veterans, always.
Written by Walt Brenner, Owner at Walt’s Insulation, serving the Dallas-Fort Worth metro since 2000.