Owens Corning Attic Insulation Nationwide | Walt’s Insulation

Owens Corning Attic Insulation: The San Antonio Owner’s Guide

Owens Corning attic insulation replacement in San Antonio typically runs $1.40 to $3.10 per square foot installed, depending on whether you’re topping off existing batts or starting fresh with blown-in fiberglass. We stock Owens Corning AttiCat blown-in and EcoTouch batt products on our trucks, and most San Antonio attics are done same-day.

Call (866) 751-4428

Most homeowners discover the problem the same way: the upstairs bedroom won’t hold temperature in July, the electric bill jumped $60 or $80 from last summer, or they crawled up to grab holiday decorations and found the insulation flattened, matted, or missing in patches. Insulation doesn’t fail with a bang. It fails quietly, usually after a roof leak, rodent traffic, or years of South Texas heat baking the R-value out of it.

Key Takeaways:

• Owens Corning fiberglass insulation degrades faster in San Antonio attics that hit 140°F-plus, especially if it’s been compressed or water-damaged
• We match the product to your existing installation, whether that’s AttiCat blown-in, EcoTouch batts, or older Owens Corning lines
• Most replacements are a same-day job with a live person answering your call at (866) 751-4428

Which Owens Corning Models This Applies To

We work with the full Owens Corning residential attic lineup: AttiCat Expanding Blown-In Fiberglass, EcoTouch PINK Batts, Thermal Batt, and older Pink Panther product lines from the 1990s and 2000s. The AttiCat system is the most common in San Antonio because it’s what builders and retrofit crews have used for the past twenty years, and it’s what we most often find when a homeowner calls about failing or settled insulation.

Here’s what matters for compatibility: blown-in fiberglass settles over time. A 2005 AttiCat install that started at R-38 may have settled to R-25 or worse, especially if roof leaks or foot traffic compressed it. Batts are more straightforward to match, but EcoTouch batts from different years have different widths, and older San Antonio homes with 24-inch on-center framing need a different size than newer 16-inch layouts. We match what’s already up there by reading the facing, measuring the depth, and checking the bag labels. You don’t need to know the exact model, just call us and we’ll identify it on site.

One thing worth saying plainly: we’re an independent installer, not affiliated with Owens Corning. We stock their products because they’re reliable and widely available, but the warranty on the material comes from Owens Corning, and the warranty on the installation comes from us. That’s the lifetime Done Right Promise: if it’s not done right, we make it right. No runaround.

Signs Your Owens Corning Attic Insulation Is Failing

• Hot rooms directly under the attic while the rest of the house is fine. This usually means insulation has shifted, settled, or was never evenly installed. We see it most in San Antonio homes with vaulted ceilings or bonus rooms over garages.
• Electric bills climbing year over year without a change in habits. Degraded or compressed fiberglass loses R-value. What was R-38 in 2010 might be performing at R-24 today, and the air conditioner runs longer to compensate.
• You can see the tops of the ceiling joists. The joists should be completely buried. If they’re visible, you’re below code minimums and your attic is under-insulated, full stop.
• Pest droppings, nesting material, or trails through the insulation. Rats and squirrels in San Antonio love fiberglass. They tunnel through it, compress it, and leave waste that degrades the material. This is also a health issue, not just a comfort one.
• Water stains on ceiling drywall or damp, matted insulation. A roof leak doesn’t just damage drywall. Wet fiberglass loses most of its insulating value and can hold moisture against roof decking, which leads to mold. We handle insulation removal and replacement when leaks have done real damage.

Replacement Cost & What’s Included

For San Antonio homeowners, blown-in Owens Corning AttiCat fiberglass runs $1.40 to $2.10 per square foot for a full removal and re-insulation, while batts run $1.80 to $3.10 per square foot depending on R-value and attic access difficulty. Topping off existing insulation with additional blown-in runs lower, usually $0.80 to $1.30 per square foot, because we’re not removing the old material first.

What drives the price: attic height and accessibility, how much old material needs removal, whether air sealing is included (it should be, in most San Antonio attics), and whether we’re dealing with rodent cleanup or water damage. Every quote includes the material, the labor, the clean-up, and our lifetime workmanship guarantee. We give upfront pricing before any work starts, and we’ll do a free second opinion on any written estimate you already have. No trip charge inside our service county. Seniors and veterans get 10% off, always.

DIY or Call Us?

You can safely check a few things yourself: measure your insulation depth with a ruler, look for visible joists, check for pest droppings, and note any damp or discolored spots. That gives us a head start when you call.

Here’s where DIY goes wrong: fiberglass handling without proper PPE means skin irritation, eye damage, and respiratory problems. Blown-in insulation requires a specialized machine most San Antonio rental shops don’t maintain well. Batt installation in a Texas attic means working in 130-degree heat with decking you can fall through if you step wrong. And if you’ve had rodents, you’re dealing with contaminated material that shouldn’t be disturbed without proper containment. We have the equipment, the respirators, and the experience to do it safely in an afternoon. Call (866) 751-4428 and we’ll tell you straight if this is a job worth doing yourself. It usually isn’t.

FAQs